Moog WERKSTAYY-01 Manual de usuario descargar pdf (Pagina 11)

11

4) POWER / LED TEST

Using only the included

power supply, connect the

barrel end to the power sup-

ply input of your Werkstatt;

connect the other end to

an AC wall outlet (100-240

VoltsAC/50-60Hz).Atthis

point,theredLEDonthe

frontpanel(LFO)should

begin blinking. If it does,

you’re ready to move on.

NOTE: Unplug the power

supply from the Werkstatt

before proceeding.

YOUR WERKSTATT IS NOW COMPLETE.

Place the 13 button caps on

the keyboard buttons.

Place the Top Panel in

position so that all of the

knobs, switches, and key-

board buttons pass through

the corresponding holes.

SecuretheTopPanelusing

thefour(x4)blacksheet

metal screws. The screw

holes in the Top Panel

should line up with the screw

holes in the Bottom Chassis.

NOTE: Tightening these

screws may require a little

extra effort the rst time,

as these screws must cut

threads into the metal holes.

5) ATTACHING KEYBOARD BUTTONS

6) ADDING THE TOP PANEL

1 2 ... 6 7 8 9 10 11 12 13 14 15 16 ... 28 29

Comentarios a estos manuales

Sin comentarios