Moog WERKSTAYY-01 Manual de usuario descargar pdf (Pagina 10)

3) INSTALLING THE ELECTRONICS

A) Carefully remove the Printed Circuit Board from the protective sleeve.

Take the washer you prepared in the previous step and slide it onto the

audio output jack, lining up the missing section with the metal tab on

the jack.

B)PlacethePrintedCircuitBoardintotheBottomChassis.Slidetheaudio

jackthroughthejackhole,andbesurethevemountingholesinthe

Printed Circuit Board line up with the standoffs on the Bottom Chassis.

 Usingthesilverpanheadmachinescrews(x5),looselyattachthePrinted

Circuit Board to the chassis. Take a moment to make sure everything is

lined up neatly and correctly—including the power input jack—and then

go ahead and tighten the screws.

Finally, place the black nylon hex nut on the audio jack, and hand-tighten

the nut to hold the jack securely to the Bottom Chassis.

A. B.

1 2 ... 5 6 7 8 9 10 11 12 13 14 15 ... 28 29

Sin comentarios

Moog WERKSTAYY-01 Manual de usuario Pagina 10