Moog QSD SERIES Manual de instrucciones

www.moogvideolarm.comQ S DQView™ Series QSD 12" Outdoor Surveillance DomeInstallation and Operation Instructions for the following models:QSDPT2-

AC VoltmeterCameraMonitorBridge TapNV-213ANV-213ANVT TROUBLESHOOTINGIf you are experiencing problems, attempt to simplify your setup. Test e

Power SupplyPower APower BCameraAssemblyPrimaryPowerVideo SignalVideo ShieldMonitor(Ground Return)Figure A Ground LoopTROUBLESHOOTINGIf you experience

Product Registration/WarrantyThank you for choosing Moog Videolarm. We value your patronage and are solely committed to providing you with the highes

IMPORTANT SAFEGUARDS SAFETY PRECAUTIONSUNPACKINGSERVICE1 Read these instructions.2 Keep these instructions. 3 Heed all warnings 4 Follow

Limited Warranty for Moog Videolarm Products Moog Videolarm warrants these products to be free from defects in material or workmanship as follows:PROD

ELECTRICAL SPECIFICATIONS (OUTDOOR ONLY): Power 24Vac, Class 2 Only 26 watts at 24Vac Heater and BlowerHeater: 25 watts Blower: 1 watt

Figure 3Twist and SecureWiring Color Code for Power1 Camera Power (24Vac) Red2 Camera Power (24Vac) Orange3 Accessory Power (24Vac) Yellow4 Accessory

Power Supply Cable Maximum Length (feet/meters)NOTE: The above table is based on a "worst-case" power supply. Using a regulated or switching

CAMERA ADJUSTMENT1. Access the cameras by removing the dome. Loosen the locking screws on the lip of the dome. DO NOT TAKE THESE SCREWS OUT. Once the

NOTE: This hi-res color camera uses a 1/4" chip and a 3-6mm auto iris lens. It is comparable to a 1/3" chip using a 4-9mm auto iris lens.Th

!!3 Wiring NotesWire — What to DO1. DO use point-to-point Unshielded Twisted Pair wire, gauge 24 or thicker, stranded or solid, Category 2, 3, 4, or