Moog Minimoog Manual de servicio descargar pdf (Pagina 10)

- 10 -

Section VI: Cover Removal and Sub-assembly Replacement

In order to service the Mini-Moog circuitry, it is necessary to remove the rear cover assembly.

CAUTION:

Be sure the unit is unplugged before removing the cover.

Remove 18 screws (5 top, 5 lower back, and 4 each end of cover); then lift the cover off.

Circuit boards are plugged into sockets at the bottom and secured at the top with two mounting

screws. To remove a circuit board, first remove the screws then unplug from the connector.

When replacing, be sure board is firmly seated in the connector before tightening the mounting

screws. Remember to re-install the fiber washers between the boards and the frame.

After board replacement, refer to Section VII: Adjustment Procedures and Locations, to

determine which adjustments should be made.

1 2 ... 5 6 7 8 9 10 11 12 13 14 15 ... 23 24

Sin comentarios

Moog Minimoog Manual de servicio Pagina 10